lineage_kernel_xcoverpro/Documentation/devicetree/bindings/power/reset/gpio-restart.txt

55 lines
2.3 KiB
Plaintext
Executable File

Drive a GPIO line that can be used to restart the system from a restart
handler.
This binding supports level and edge triggered reset. At driver load
time, the driver will request the given gpio line and install a restart
handler. If the optional properties 'open-source' is not found, the GPIO line
will be driven in the inactive state. Otherwise its not driven until
the restart is initiated.
When the system is restarted, the restart handler will be invoked in
priority order. The gpio is configured as an output, and driven active,
triggering a level triggered reset condition. This will also cause an
inactive->active edge condition, triggering positive edge triggered
reset. After a delay specified by active-delay, the GPIO is set to
inactive, thus causing an active->inactive edge, triggering negative edge
triggered reset. After a delay specified by inactive-delay, the GPIO
is driven active again. After a delay specified by wait-delay, the
restart handler completes allowing other restart handlers to be attempted.
Required properties:
- compatible : should be "gpio-restart".
- gpios : The GPIO to set high/low, see "gpios property" in
Documentation/devicetree/bindings/gpio/gpio.txt. If the pin should be
low to reset the board set it to "Active Low", otherwise set
gpio to "Active High".
Optional properties:
- open-source : Treat the GPIO as being open source and defer driving
it to when the restart is initiated. If this optional property is not
specified, the GPIO is initialized as an output in its inactive state.
- priority : A priority ranging from 0 to 255 (default 128) according to
the following guidelines:
0: Restart handler of last resort, with limited restart
capabilities
128: Default restart handler; use if no other restart handler is
expected to be available, and/or if restart functionality is
sufficient to restart the entire system
255: Highest priority restart handler, will preempt all other
restart handlers
- active-delay: Delay (default 100) to wait after driving gpio active [ms]
- inactive-delay: Delay (default 100) to wait after driving gpio inactive [ms]
- wait-delay: Delay (default 3000) to wait after completing restart
sequence [ms]
Examples:
gpio-restart {
compatible = "gpio-restart";
gpios = <&gpio 4 0>;
priority = <128>;
active-delay = <100>;
inactive-delay = <100>;
wait-delay = <3000>;
};